Product Overview

Terramix Fine is formulated for plastering and repair of exterior and interior surfaces. It gives a hard, smooth, water resistant, high quality finish, suitable for painting and wall papering. Terramix Fine is trowel / spray applied to a thickness of 1mm to 3mm and levelled with a steel float. Smooth finishing can be achieved with a wooden / foam float when the Terramix Fine has set. The float should be moistened during the smoothing operation.

Properties

• Ready to use
• Smooth surface
• Excellent adhesion
• Water resistant
• Crack resistant

Areas Of Use

• Plastering and repairing of cast-in-situ concrete
• Lightweight concrete
• Fair-faced dense concrete
• Concrete blockwork
• Brick work

Application Method

Surface Preparation:

Ensure the surface to be covered is free of loose particles, dust, dirt, grease, oil, and paint. Absorbent and porous substrates should be moistened with water prior to the application of Terramix.

Bonding:

Under extreme climatic conditions and on very absorbent or porous surface the standard code of practice for the use of cementitious products should be followed. Priming and/or the addition of Terrabond A to the mixing water in the ratio of
1:15 is recommended.

Mixing:

Mix thoroughly with the recommended water addition in a high speed mixer (such as the Terraco SM 50 or SM 100) or with a hand agitator for 3 – 5 minutes. In normal conditions, let Terramix stand for 5 minutes, then re-stir and use.

Application:

Terramix is trowel applied and levelled with a steel float. Smooth finishing can be achieved with a wooden or foam float when the Terramix has ‘set’. The float should be moistened during the smoothing operation. A completely smooth surface is obtained if loose particles are removed with a soft brush when the Terramix is dry.

Terramix should not be allowed to stand unused in spray equipment for longer than 30 minutes.

Clean tools and equipment with water after use.

Available Grades

Product Overview

Terramix Fine is formulated for plastering and repair of exterior and interior surfaces. It gives a hard, smooth, water resistant, high quality finish, suitable for painting and wall papering. Terramix Fine is trowel / spray applied to a thickness of 1mm to 3mm and levelled with a steel float. Smooth finishing can be achieved with a wooden / foam float when the Terramix Fine has set. The float should be moistened during the smoothing operation.

Properties

• Ready to use
• Smooth surface
• Excellent adhesion
• Water resistant
• Crack resistant

Areas Of Use

• Plastering and repairing of cast-in-situ concrete
• Lightweight concrete
• Fair-faced dense concrete
• Concrete blockwork
• Brick work

Application Method

Surface Preparation:

Ensure the surface to be covered is free of loose particles, dust, dirt, grease, oil, and paint. Absorbent and porous substrates should be moistened with water prior to the application of Terramix.

Bonding:

Under extreme climatic conditions and on very absorbent or porous surface the standard code of practice for the use of cementitious products should be followed. Priming and/or the addition of Terrabond A to the mixing water in the ratio of
1:15 is recommended.

Mixing:

Mix thoroughly with the recommended water addition in a high speed mixer (such as the Terraco SM 50 or SM 100) or with a hand agitator for 3 – 5 minutes. In normal conditions, let Terramix stand for 5 minutes, then re-stir and use.

Application:

Terramix is trowel applied and levelled with a steel float. Smooth finishing can be achieved with a wooden or foam float when the Terramix has ‘set’. The float should be moistened during the smoothing operation. A completely smooth surface is obtained if loose particles are removed with a soft brush when the Terramix is dry.

Terramix should not be allowed to stand unused in spray equipment for longer than 30 minutes.

Clean tools and equipment with water after use.

Available Grades